via-diag - EEPROM setup and diagnostic program for the VIA Rhine vt86c100
and vt3043 Ethernet controller chips.
SYNOPSIS
via-diag [ options ]
DESCRIPTION
via-diag is a program that you can use to diagnose problems with
VIA Rhine vt86c100 and vt3043 Ethernet controller chips.
OPTIONS
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (`-').
A summary of options is included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-# <cardnum>
Use card number <cardnum>.
-a, --show_all_registers
Print all registers.
-e, --show-eeprom
Dump EEPROM contents to stdout.
-E, --emergency-rewrite
Re-write a corrupted EEPROM.
-p, --base-address <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx,
100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2, AUI,
100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX,
MII, HomePNA and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
-m, --show-mii
Dump MII management registers.
-R, --reset
Reset the transceiver.
-T, --test
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
-f, --force-detection
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run via-diag with the options '-t -1'.
SEE ALSO
mii-diag (8)
AUTHOR
via-diag was written and is still maintained by Donald Becker
<becker@scyld.com>.
This manual page was written by Alain Schroeder <alain@debian.org>,
for the Debian GNU/Linux system (but may be used by others).