3C5X9SETUP (8) manpage
- NAME
3c5x9setup - setup program for the 3Com 3x9 cards.
- SYNOPSIS
- DESCRIPTION
3c5x9setup is a program that you can use to setup 3Com 3c5x9
series ethercards.
- OPTIONS
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (`-').
A summary of options is included below.
- -h, --help
- Show summary of options.
- -v, --version
- Show version of program.
- -V, --verbose
- Verbose mode
- -D, --debug
- Show Debug messages
- -a, --all
- Print all registers
- -p, --base-address <port>
- Specify port to use
- -E, --emergency-rewrite
- Re-write a corrupted EEPROM
- -f, --force-detection
- Force if card is busy
- -F, --new-interface <type>
- Interface type to be used. This can be 10baseT, 10base2 or AUI.
- -P, --new-IOaddress, --new-base-address <port>
- New base I/O address
- -H, --new-hwaddress <addr>
- New base hardware address
- -Q, --new-irq <irq>
- Specify interrupt number
- -w, --write-EEPROM <values>
- Write to the EEPROMS with the specified values.
- SEE ALSO
- AUTHOR
This manual page was written by Alain Schroeder <alain@debian.org>,
for the Debian GNU/Linux system (but may be used by others).
|
